Using a sharp pencil, make small marks on the door as shown to the left. Mark both left and right side of door. Your automatic door bottom will be installed between these marks, so be sure to make marks dark enough to see, but light enough to erase. When the door bottom is finally installed, it should be approx 1/8″ short of the lines on each side
Note: All door seals over 24″ can be trimmed up to 1″ & door seals that are 36″ or 42″ can be trimmed up to 3″.
Some field trimming may be necessary for best fit. For best cut, pull neoprene gasketing out of housing and cut with compound miter saw/chop saw.
**Do not cut neoprene gasketing until you are sure the door bottom fits exactly.